Admin time calculator for aged care
Phones, family updates, progress notes, shift fill calls and report preparation take hours every week from care, clinical and office staff. Enter your own figures to see the weekly total, the share a reasonable level of automation might take on, and what that time costs over a year.
All defaults are illustrations only. For better figures, ask a few staff to tally these tasks for one normal week, then enter the totals for one site or one team.
Aged care admin time calculator
Weekly totals for one site or team. Never enter resident, client or staff information.
Illustrative default.
Calls back, emails and texts to families. Illustrative default.
Illustrative default.
Illustrative default.
Internal, board and quality reports. Illustrative default.
Round placeholder. Replace it with your own figure.
The value of the freed hours at your staff cost, rounded to the nearest $100.
An estimate from the figures you entered, not financial or workforce advice. Defaults are illustrations only. Enter aggregate figures only: no resident, client or staff information should be entered into this or any similar web tool.
Reading the result
The headline figure is the annual cost of the hours you assumed automation could take on. It is only as good as the inputs, and the automation share is your own assumption. Treat it as a way to compare tasks and decide where to look first.
Freed time goes back into care
In most aged care services, hours saved on admin go back to residents and clients: a registered nurse who finishes notes within the shift, or a coordinator who returns family calls the same day. The dollar figure shows the value of that time. Whether it lowers the wages bill depends on how you choose to use it.
The automation share is an assumption
The default of 30 per cent is a deliberately conservative starting point and is your assumption, not a measured result. Some tasks, such as answering routine phone questions, can be handled largely by an AI agent with staff oversight. Others, such as progress notes, still need staff to review and approve every entry, so the time saved per note is smaller.
Look at the largest single line
Most services find one task dominates. In a residential home it is often progress notes and family calls. In home care it is often phone calls, rescheduling and shift fills. Start with the largest line, measure it properly for a fortnight, and pilot one change there before looking at anything else.
How the figure is built
The calculator adds up minutes across five task types, converts them to hours, applies your automation assumption and values the result at your staff cost.
Weekly minutes per task
Phone minutes per day multiplied by the days the calls come in, plus each count of messages, notes and shift fill calls multiplied by the minutes each takes.
Weekly hours
Total minutes divided by 60, plus the hours you spend preparing reports each week.
Hours that could be freed
Weekly hours multiplied by your automation share. Change this input to see how sensitive the result is.
Annual hours and cost
Freed hours multiplied by 52, then by your average hourly staff cost including on-costs.
FTE equivalent
Freed weekly hours as a share of one full-time role at 38 hours per week.
Where the admin time goes
Each input maps to a task where AI can draft, summarise, route or remind while staff keep the decisions. Here is what that looks like in practice for each line in the calculator.
Phone calls
Front desks and coordinators field calls about visiting, appointments, rescheduled home care visits, invoices and new enquiries, often while doing something else. An AI phone agent can answer routine questions from information your team approves, take messages with the details staff need, and put urgent or upset callers through to a person.
- Count calls by type for a week to find the routine ones
- Write down which questions staff are happy for an agent to answer
- Keep a clear path to a person for anything clinical or urgent
Family messages
Families want to know how a parent is going, whether an appointment went ahead and what is happening with a change in care. AI can draft updates from information staff have already recorded, for a staff member to check and send. It does not decide what a family is told about a clinical matter.
- Use approved templates for routine updates
- Have staff review every message that mentions health or care
- Record what was sent in your care system
Progress notes
Writing notes at the end of a shift is one of the most common sources of unpaid overtime. AI can turn a care worker's short spoken or typed points into a draft note in your preferred format. The care worker or nurse reads, corrects and signs it. The saving per note is real but modest, because review stays in place.
- Measure minutes per note before and after any trial
- Keep staff sign-off on every note
- Check what your care management system allows to be written into it
Shift fills and reports
When a shift opens at short notice, someone rings or texts down a list of staff until it is filled. Automation can send the offer to suitable staff at once and record who accepts, with a rostering officer confirming. Report preparation, such as monthly board packs and internal quality reports, can be drafted from data your systems already hold, with a manager checking every figure.
- Track how long each short-notice fill takes today
- Keep a person approving every roster change
- Start with one recurring internal report as a pilot
Next steps
Progress notes support
How AI drafts progress notes from staff input while staff review and sign every entry.
Read the guide →Rostering and shift fill
Sending short-notice shift offers to suitable staff and recording who accepts.
See how it works →Missed enquiry calculator
Estimate the value of enquiry calls your service loses to an unanswered phone.
Run the numbers →Frequently asked questions
How do I measure how much time staff spend on admin?
Pick one normal week and ask a small group of staff to keep a simple tally: number of calls and their rough length, family messages, notes written and the minutes each took, shift fill calls and time on reports. Phone system reports help with call volume. A week of tallies is more reliable than a guess in a meeting, and it gives you a baseline to measure any change against.
What hourly cost should I use?
Use your average cost per hour for the staff who do these tasks, including on-costs such as superannuation, leave and workers compensation. If the work is split between care workers, nurses and office staff, use a blended figure or run the calculator once for each group. The default is a round placeholder for illustration and should be replaced with your own figure.
Why is the automation share set to 30 per cent?
It is a conservative illustration chosen so the result is not overstated. It is not a benchmark or a measured saving. The right share depends on the task, your systems and how much staff review you require. Set it lower for tasks like progress notes, where staff approve every entry, and test the real figure with a small pilot before relying on it.
Does AI write progress notes or care plans on its own?
No. AI can turn a care worker's points into a draft in your format, but qualified staff read, correct and approve every note, and care decisions stay with your clinical team. AI does not diagnose, make medication decisions or decide on care. The time saved comes from faster drafting, and the accountability for the record stays with the staff member who signs it.
Will this reduce our staffing costs?
It can, but it does not have to. Freed time can cover work that is currently squeezed or done in unpaid overtime, such as returning family calls, completing documentation within the shift and supervising new staff. The calculator shows the value of the time so you can decide where it goes. It does not assume anyone loses hours.
Are the hours and wage figures I enter kept private?
Yes. The admin time estimate is worked out in your browser and nothing is sent to us. Your task times and hourly cost are kept in your own browser storage so they remain if you return, and the reset button clears them. Use weekly totals and average rates only, never resident, client, family or staff names or any other personal information.
Want a clearer picture of your admin load?
Book a free 30-minute assessment. We will go through your figures, identify the task taking the most time and outline what a small, measurable pilot could look like.